Cast or extruded acrylic? Choose for the finished part, then record the sheet

Acrylic is one of the most popular materials for laser cutting and engraving, but the word covers two products made in different ways. Cast and extruded acrylic look the same on the shelf. They behave differently under a laser, and picking the wrong one is a common reason a project looks dull or a fitted part comes out loose.

What each one is better at

Trotec's acrylic processing guidance draws a useful distinction for CO2 laser work:

Edge appearance is discussed for both, and depends on the machine and process, so treat any finish claim as specific to the setup it was made on.

Ask the supplier the right question

For each job priority, there is one question worth asking before you buy:

Keep the sheet's identity with the job

Record the supplier, product identifier, cast or extruded label, colour, stated thickness and any masking. Keep the material safety document too. If an offcut has lost its label, leave its identity unresolved rather than naming it from appearance.

For fitted parts, measure the actual thickness of the sheet you are using and record it separately from the nominal size in the listing. A 3 mm sheet is a description, not a measurement.

Check the laser family before copying settings

Acrylic results shared online usually come from CO2 lasers. Diode lasers interact with clear and some coloured acrylic very differently because of their wavelength, and may not cut clear acrylic at all. A setting that works on one laser family is not a recipe for another.

CutChart's cast vs extruded acrylic guide explains the distinction with sources, and its acrylic safety page collects manufacturer statements on processing acrylic.